DEWALT Metal Shear/Cutter Drill Attachment, Impact Ready, 360 Degree Pivoting Head, Cuts 18GA Material (DWASHRIR)(Yellow, Black)

Bought this on amazon deals to add to my tools collection. I’m happy so far with what it offers. Previously, I had to cut chicken wires few times, for the fence and for my raised garden bed bedding. I had bought a nail cutter and had to cut each mesh one by one. It was pretty time consuming. I used this couple times lately agin to cut chicken wires for my projects. The cutting process was so much quicker. i tried with both my impact driver and drill. Works for both. A little easier to set up with impact since it is impact ready, I wish I had bought this sooner.

Wonderful tool!! Absolutely great tool, should have bought one long ago.Ease of use can't be beat. Designed to easily connect to a Dewalt driver and then the speed at which you can cut/shear makes the job a breeze.I used it for aluminum siding as well as vinyl siding and I can't say enough about how much time and work it saved me by not having to cut everything with snips. Not made for cutting lapped surfaces but long flat runs or curves/circles it does a great job.Great investment., highly recommend.

Handle clip didn’t fit rigid tools.Takes some getting used to cutting sheet metal, does a good job. Can cut straight if go slow.

I needed to replace the fascia on a manufactured home. Because the dimensions were not the standard 6 or 8 inches, I had to do some 16-foot cuts down the length of the aluminum fascia so it would slip under the drip edge and sit flush with the vinyl soffit. My 64-year-old wrists were not going to enjoy that, so I figured that for the price, this was worth a shot. Boy, am I impressed. The tool fit onto my Porter Cable drill and functioned with no problems, and it literally took less than a minute per piece to cut the entire length. Since this only leaves one flat edge, I kept the scrap side to my right. It cut the aluminum like butter, and the remaining cut edge was perfect.I also used this to cut 12-inch holes in a plenum to add some cold air returns, and it worked great. The jaws do not open very far, so going over corners and bends is not so great. It also takes some effort to cut across a seam. It is not a cure-all, but for the price it is a great tool to have in your arsenal.

Good tool to have just be careful, it will leave one side of the metal (if youre using it for metal) looking a bit torn up so i would use it for any undercuts where you wont want those wrinkles showing

I bought this for cutting ribbed steel pole barn siding and it works great. Works great on long rips as well as cross cuts over the ribs.

These work good. Just attach to drill gun saves ur hands when u have to cut some long pieces of metal.good for the price.use it bunch of times at work still holding up good

Not as easy to use as I expected it doesn't cut metal roofing ridges. I had to use regular hand cutter on the ridges